Senior Electrical Engineer seeking work abroad

• Graduated Bachelor of Science in Electrical Engineering from the University of San Carlos (Cebu City, Philippines) on 1988
• Registered Electrical Engineer (certified by the Professional Regulation Commission - Philppines), Professional registration 23244 dated 22 June 1996
• Lifetime member of the Institute of Integrated Electrical Engineer - Philippines
• Can make and accomplish detailed design and calculations for the power and distribution system (low voltage and high voltage), power system sizing i.e. sizing of cable, load calculation, UPS, battery and charger/rectifier, transformer, instrument transformers (current transformers and voltage transformers), neutral earthing resistor, high voltage (HV) & low voltage (LV) switchgears, motor control center, lighting, lightning protection system, earthing system, electric heat tracing, fire alarm system, lighting illumination calculations, earthing calculation, tray layouts, schematics, wiring diagram, cable schedule, etc.
• Development of power system single-line diagrams, data sheets, control gears, motor schematic diagram, wiring diagrams, cable tray schedules and etc.
• Deep knowledge in power/distribution transformers, motor control centers, high voltage and low voltage switchgears, protective relaying (including arming and setting), variable speed drives, soft starters, autotransformers, UPS, cables, cable bus, LMS/DMS, interposing relay panel, automation, diesel generators, automatic transfer schemes, circuit breaker operation matrix in switchgear applications, circuit breaker interlocking with upstream and downstream protections, P&ID
• Can do electrical systems case studies such load flow, short circuit/fault calculations, large motor start-up, protective relaying and protective relay coordination studies, etc.
• Thorough knowledge of IEC, DEP (Shell), PTS (PETRONAS), SAES (Aramco), IEEE, NFPA, NEMA, ANSI, GOST
• Can do Front End Engineering Design (FEED)
• Can do technical specifications and electrical data sheets of major electrical equipment
• Familiar with hazardous area classification and protection techniques (IEC 60079)
• Onshore and offshore design experience
• Can do technical bid evaluation (TBE)
• Construction/project management, execution and supervision.
• Experience in field inspection and acceptance testing of electrical equipment
• Design physical layout of electrical equipment, raceway and earthing plans
• Preparation of cable and raceway routing layouts
• Material quantity estimating/material take off (MTO)
• Review of engineering deliverables
• Proficient in engineering software i.e. ETAP, Thermotrace, Autocad, Luxicon, Chalmlite, MS Office, etc.